CAP200D3 - Cherokee International CAP200D3 Power Supplies. 200W Single & Multiple Output Modular Supply

CAP200D3 - Cherokee International CAP200D3 Power Supplies. 200W Single & Multiple Output...

Cherokee International CAP200D3 Power Supplies. 200W Single & Multiple Output Modular Supply Simple Type: Power Supply

For Resellers and High Volume Orders:
Please request a quote to obtain preferred pricing.

General

Dimensions: 8.50” x 4.95” x 1.5”
Efficiency: 70% typical (measured at full load)
EMI: FCC and VDE Level “B” (Conducted)
Hold-Up Time: 20ms at full load, low line for V1, V2 and V3. 3ms on V4
Input Current: 3.3A max. (at 90VAC)
Input Protection: Single fuse (6.3A, 250VAC / HB Type)
Input Voltage Range: 85-264VAC; 47-63Hz (Continuous range operation)
Inrush Current: (Cold Start) 35A @ 115VAC, 70A @ 230VAC typical
Maximum Output Power: 200 Watts Continuous
Operating Temperature: 0~50ºC. Derates linearly from 50ºC to 70ºC at 2.5% per ºC, 200 LFM Required for Full Power
Output Ripple & Noise: 1% or 50mV (whichever is greater) pk-pk maximum @ 20MHz
Over Current Limit: 110 - 135% of max Iout. Output recovers when the fault is removed
Over Voltage Protection: Trip point set at 120% - 130% of V1 or V2. To reset, cycle input power
Regulation: +/- 2% max of V1 / V2 / V3, V4 is +/-4%
Shock & Vivratio: n Per MIL STD-810E per 516.4 Part IV
Status & Control Signals: Remote Sense (Compensates 5% of V1 & V2 only), Remote on/off (TTL Low or Short - Off, Open Collector), Input Power Fail (TTL High for normal operation, goes low >4ms before loss of regulation), DC Good Signal (TTL High for normal operation, Open Collector)
Total Power Over-Load Limit: Set at 240W typical by sensing the primary input current
Transient Response: Peak deviation of ± 3% with a 25% step load change at 3A/µs slew rate
Voltage Adjustment Range: +/-5% of V1 / V2 / V3 only, V4 is fixed